Fishers, Indiana, United States
Anthony is a graduate of the automotive engineering master's program at Clemson University's International Center for Automotive Research (CU-ICAR) in Greenville, South Carolina. He has strong interests mechatronics and control systems, especially in regards to design, modeling, simulation, and diagnostics. He has international engineering and cultural experience with a particular attachment to Germany, and is comfortably fluent in German. Anthony has previous internship and professional experience in the U.S. and Germany in the areas of process engineering for machine tools, quality assurance, data acquisition, automotive modeling and simulation for on-board diagnostics, and accelerated-aging component testing. He is comfortable in a lab or workshop environment, where he is quite capable with hand tools. He is quite fond of taking things apart and has nearly always successfully put them back together. He completed the University of Rhode Island's International Engineering Program (IEP) in December, 2011, earning a BS in mechanical engineering and a BA for his studies of German language and culture. As part of the IEP, Anthony spent a year studying and interning abroad in Braunschweig, Germany. Anthony loves photography and swing dancing, and he wrote this whole thing about himself entirely in the third person.
Software engineer responsible for: - Implementing vehicle models and Restbus logic for virtual vehicle ADAS V&V testing - Implementing virtual test scenarios - Tool development for analysis of ADAS system performance KPIs - Other general tool development
Application engineer responsible for: - Calibration of radar-based ADAS systems - Vehicle integration testing - Test track and test bench (Restbus) verification and validation of radar-based ADAS systems - Diagnose issues with test equipment hardware, embedded sensor exceptions, etc. - Ensuring international regulatory compliance and meeting targets of consumer safety testing for AEB systems - Software development and unit testing of ADAS functionality in embedded systems - Software tool development I drive cars at things and hope that they stop, then I write some documentation about if they did or didn't stop, then sometimes I write some code to make sure that they do stop.
• Performed photogrammetric deformation studies and gap measurement on automotive assemblies • Assembled test parts • Configured electromagnetic shaker table and climatic test chambers • Validated laboratory sensors and measuring equipment From January 2015 through August 2015, the same role was fulfilled at this facility as a graduate engineering intern.
• Driving simulator lab • Contributed to development of procedures for capturing, organizing, and analyzing participant data in a distracted driving study • Analyzed survey data from participants and parsed video data of participants in driving simulator
• Developed machining processes to achieve geometric and surface finish specifications on client workpieces and wrote test reports • Designed, machined, and installed test tooling for process development on client workpieces • Operated and maintained lab machine tools and measurement equipment • Measured incoming and superfinished parts for geometric and surface finish tolerances • Configured machine process parameters, calibrated sensors and in-process quality gauging, and wrote detailed machine setup procedures • Commissioned Supfina machines at client facilities and led machine run-offs • Spent time training in Germany to configure and operate machine tools from Supfina's parent firm • Gained limited experience with Allen Bradley PLC ladder logic programming
• Made regular test drives and recorded powertrain data under different environmental and driving conditions via CAN bus and supplemental sensors on company's test track and public roads • Extensively re-developed a MATLAB/Simulink tool to analyze vehicle test drive data from ETAS INCA and optimize vehicle model parameters for on-board diagnostic functions • Developed OBD-II fault diagnostic functions for US and EU series-production diesel vehicles